Therefore, computers connected to the primary router will be unable to reach computers connected to the client router. For this reason, option 1 is generally the best option to connect two routers and extend the range of your network.
What is a Router Bridge? How to Connect Two Routers? Router Behind Router Client Bridge. Router Behind Router Ethernet Bridge. In this configuration, two Cisco routers are connected back-to-back through the asynchronous AUX ports with the help of a null modem cable rollover cable.
This cable can be purchased from most retail electronic outlet stores. Verify whether your DBto-DB null modem cable has the pin connections indicated in table 1.
In this section, you are presented with the information to configure the features described in this document. Note: To find additional information on the commands used in this document, use the Command Lookup Tool registered customers only. Admin asked a question. Heyy when you try connecting two routers in a WAN,i read it happens this way..
The ISP determines what your clock speed and duplex and that sort of thing is for your serial wan link. That then makes them the DCE end. The above thread also goes into good detail that might help clear it up for you. Also different routers can have 2 kinds of serial interfaces as far as I know from my studies theres a a T1 WIC which is the older bigger style with alot of pins, the WIC 2T I believe is the thinner one that sort of looks like a type of SCSI connection.
This link below will explain a WIC 2T interface card. As you can see, very different connections, but both are serial WAN interfaces. Its important to know the difference. Sorry about all the information - Hope it helps please correct if I explain something wrong or overly complicated anything.
Mustafiz, whether using PT or real routers, when we connect routers like this, its called a serial back to back connection. Its only done in labs to simulate a WAN its actually a kind of crossover cable. So, in packet tracer do this: connect two routers using the serial cable that has the little clock icon on it. You don't need to add IP addresses, just issue the no shutdown command on each serial interface.
Now, on the side that has the little clock icon, run the show controllers command, like this:. Connect and share knowledge within a single location that is structured and easy to search. I'm new to Cisco and I wanted to connect two routers with serial connection.
This is how my network looks now:. So I had an idea that there aren't routes between my FastEthernet and Serial ports and I tried to do that but I'm not sure how or if that's even the right approach. As I said I'm new to this and my knowledge is not large but please if you have any directions, I'd very much appreciate it! Also I'm sorry if I used any wrong terminology since that's also new to me! All of them have subnet of Router1 has an IP of Also My ultimate goal is to be able to ping from PC0 Sign up to join this community.
The best answers are voted up and rise to the top. Stack Overflow for Teams — Collaborate and share knowledge with a private group.
0コメント